DELTAC® Mini "MAGNUM" muzzle brake for Mosin Nagant - Complete threading kit

Description

We believe that threading the barrel of the Mosin Nagant is the most effective method to install a muzzle break on your Mosin Nagant because their manufactured barrels are not always concentric. See the picture above. There are many brakes on the market that mount with only a bracket secured behind the front sight that end up being shot off with an exiting bullet and are potentially dangerous. Threading your barrel with the use of the enclosed threading tools insure your threads are true and permanent while also ensuring reliability and accuracy. We also suggest this to be done by a gunsmith.
Designed for tactical applications that require minimal dust signature. A massive symmetrical blast baffle, redirect gas to the sides and upward delivering unparalleled recoil reduction while also minimizing muzzle rise and ground disturbance. High tolerance threads machined in same operation as bore aperture ensures perfect concentricity. Computer FEA optimized for maximum strength to weight ratio and impact survivability. Precision CNC machined from high strength steel bar for superior heat and corrosion resistance.
Muzzle Brake
Length:
2.504
inches
width : 1.25
inches
Caliber: 7.62
Exit hole: .375 inches
Thread:  M15x1 RH threads.
Machined from top quality steel and finished in black oxide.
Threading die
Right Hand Thread Adjustable Die M15 X 1.0mm Pitch
Recommended barrel OD sizes for threading is 0.5824 min and  0.5896 max
Thread alignment tool:
This is a simple TAT (thread alignment tool) for re-threading 7.62 caliber muzzles to accept the above M15 X 1 RH muzzle device.
The extended 3" long stem helps with Mosin Nagant barrels which have been counter-bored to renew the muzzle crown..
It helps you get the die started level and on-center to prevent costly mistakes.
Material: 303 Stainless Steel
#5 Die Handle
This a heavy duty #5 die handle is approx. 11.5in long and accepts 1.5in dia (38mm) dies like the M15X1 RH die that we offer on this site. These are high quality handles made of high tensile steel.
* The Russian arsenal sometimes counter-bore the barrels to prolong their life by cutting out the bad/worn rifling at the muzzle end. If done properly a counter-bore has the potential to improve accuracy.  The length of the counter-bore depended on how worn the muzzle end was. You should measure the depth of the counter-bore to make sure that this tool is long enough to reach the caliber bore of the rifle.
PKG Content
:
1 Threaded "Mini-Magnum"muzzle break
1 M15X1 RH adjustable round Die
1 Thread alignment tool with a 3" long stem
#5 die handle
1 Jam nut
NOTE: This device should be installed by a competent gunsmith to ensure concentricity and clearance at exit hole.
watch the youtube video here
https://youtu.be/mNVQzdvmqhg